Hondata Reflash FN2

Questions / support for the K-Series ECU re-flash
Locked
Akula
Posts: 20
Joined: Tue Jun 16, 2009 2:03 pm
Location: Ferrari's Land!

Hondata Reflash FN2

Post by Akula » Sat Jul 18, 2009 1:08 pm

Hello Hondata,

One question, why the reflash fn2 is so rich under 3800rpm ? (under the vtec)

Thanks in advance, best regards!

Akula

User avatar
Hondata
Site Admin
Posts: 8774
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Post by Hondata » Mon Jul 20, 2009 9:21 am

Do you have a dyno graph? If it is running rich under 3800 rpm then it could be the AFM signal is getting altered by the intake configuration.
Hondata

Akula
Posts: 20
Joined: Tue Jun 16, 2009 2:03 pm
Location: Ferrari's Land!

Post by Akula » Thu Jul 23, 2009 1:30 pm

thanks for the reply,
my fn2 is stock, i have a normal BMC panel filter only, (like K&N)

here a dyno graph:

Image

here another one, reflash on my fn2 vs another fn2 stock

Image

Best regards!
CTR FK2 R-03220

User avatar
Hondata
Site Admin
Posts: 8774
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Post by Hondata » Thu Jul 23, 2009 1:51 pm

The ECU will run closed loop for some time under full load conditions - normally until 3800 rpm, but sometimes there is a time factor as well.
Hondata

Akula
Posts: 20
Joined: Tue Jun 16, 2009 2:03 pm
Location: Ferrari's Land!

Post by Akula » Thu Jul 23, 2009 2:02 pm

thanks for the fast reply!

you mean that with passing of the time under the 3800 the ecu will change and become less rich or run more better ?

Best Regards!
CTR FK2 R-03220

User avatar
Hondata
Site Admin
Posts: 8774
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Post by Hondata » Thu Jul 23, 2009 5:53 pm

The time frame is in the order of 0-10 seconds. The ECU runs closed loop for a while after you give it full throttle, then switches to open loop. It also seems to switch at 3800 rpm to open loop.
Hondata

Akula
Posts: 20
Joined: Tue Jun 16, 2009 2:03 pm
Location: Ferrari's Land!

Post by Akula » Fri Jul 24, 2009 9:40 am

ermm, sorry Hondata but .. :)
what do you mean with "closed loop" and "open loop"

thanks!
CTR FK2 R-03220

Locked