Search found 5 matches
- Tue Aug 22, 2017 6:49 am
- Forum: s300 / SManager
- Topic: SManager software requests
- Replies: 336
- Views: 1386305
Re: SManager software requests
Can we get extra points of adjustment in the Flex Fuel scale? Currently we can adjust for ethanol content at 0, 15, 85, 100. It would be very benifixial to have more adjustment points inbetween e15 & e85. Many people use e40-e50 and it would be nice to have at least one point of adjustment inbet...
- Sun Aug 20, 2017 12:47 pm
- Forum: s300 / SManager
- Topic: Flex fuel content sensor readout
- Replies: 3
- Views: 2252
Re: Flex fuel content sensor readout
Thank you Spunkster It was wiring as I suspected. And of course it was the ONE thing that I was certain should have been good. The power source. For whatever reason the extra switch-power-source I was attempting to use on the fuse box was dead. Today I double checked my ethanol content sensor harnes...
- Thu Aug 17, 2017 5:01 pm
- Forum: s300 / SManager
- Topic: Flex fuel content sensor readout
- Replies: 3
- Views: 2252
Re: Flex fuel content sensor readout
I'll add that I have a bunch of e85 in the tank right now. And when I have Flex Fuel disabled it runs 16.0-ish. Normally on pump gas it's right at 14,7. When I enable flex fuel with Analong 0 as the input it goes rich like 13ish. But when i raise or lower the fuel enrichment in the flex fuel setup, ...
- Thu Aug 17, 2017 4:22 pm
- Forum: s300 / SManager
- Topic: Flex fuel content sensor readout
- Replies: 3
- Views: 2252
Flex fuel content sensor readout
So i have s300v3 and I hooked up my content sensor as Hondata explained. I don't think it's working Signal wire to Analog 0. I have a 2.4k resistor in between the power and signal wire. And my ground. Should I Chassis ground or ground to one of the analog "Gnd"s? Also Where do I get a read...
- Mon Aug 14, 2017 12:24 pm
- Forum: s300 / SManager
- Topic: SManager software requests
- Replies: 336
- Views: 1386305
Re: SManager software requests
Can we please get a Knock Warning Light? A light on the dash like maybe the check engine light or something.... that when Knock is detected (the set Knock count 1,2,3,4, etc... being defined by the user), a light on the dash will turn on to inform the driver that Knock is being detected. The driver ...