Hondata

Yes but if I switch to version 3 from version 1 do I get more inputs?

Ok but I have a V1

i might have figure it out.

When upgrading to V3, do you get more inputs? I think I have used all of mine.

No one knows???

Is there a sensor that can plug into the S300 to log acceleration or g's? I think i am blowing engines due to oil starvation so I would like to datalog acceleration next too oil pressure.

I changed VSS sensor out and that didnt work. So i move the ground location for the VSS to the thermostat housing and it solve the problem.

A standard intake manifold temp sensor couldn't be wired in before the intercooler? It is only a temporary set up so using the PLX wouldn't make much sense.

I thought this would be pretty simple using hondata and mani sensor.

How do I do this in hondata?

ok but i originally wanted to know how to safely increase the boost pressure based on a max duty cycle.

how is that done? Do i need to set up a senors with a warning?

I am not able to edit mine which i am assuming is because i am not using the built in boost control correct?

but that only applies when the hondata boost controller is used correct?

To actually see what the boost pressure is at a certain duty cycle, i will need to hook up the s300 while driving or datalog it correct?

Haha i did talk with the tuner but they dont remember what the pressure was set too. where or how do i set up the software to show the correlation between the duty cycle and boost pressure?

Ok so i had my car tuned a while back and i dialed the boost down because of a VSS issue (now resolved). Now i want to turn the boost back up but i dont remember what we were at initially. I do remember my tuner saying that the max boost in my car was limited to the max injector duty cycle. How can ...

yeah... the service manual shows it going to b10 and two grounds (G101 and A26). that doesn't sound right.

is there an alternate sensor that will work?

It should be wired 12v, GND and B10 correct? Should the vss be wired to the ecu ground or is the chassis fine? yeah i dont know anyone with a similar computer. Is there another Hall sensor that can be mount to the wheel instead? Will this work? http://www.xenocron.com/xenocron-wheel-speed-sensor-p-7...