How about f-Manager for Android
Phones and tablets last so much longer on battery life and so much easier to carry around than laptops.
Search found 211 matches
- Sat Dec 18, 2021 8:33 am
- Forum: FlashPro Manager
- Topic: FlashPro Requests
- Replies: 365
- Views: 455320
- Sat Dec 18, 2021 8:21 am
- Forum: Civic Type R 2007-2011 European FN2
- Topic: Honda Civic type-R FN2 2.0 201 KM P2646
- Replies: 5
- Views: 3234
Re: Honda Civic type-R FN2 2.0 201 KM P2646
Check this out https://www.700r4transmissionhq.com/p2646-honda-civic/ Stock map is made as close to stock as possible ,it's not actually the stock map, as far as I know. I've run a "pop and bangs map" successfully without issues. However this was just a few hours before it became annoying....
- Sat Jul 17, 2021 5:11 am
- Forum: FlashPro Manager
- Topic: Can someone from Hondata speak to this?
- Replies: 7
- Views: 1759
Re: Can someone from Hondata speak to this?
Some well respected tuners may get a lucrative offer to peddle another product, They won't want you to buy Hondata as its not as financially beneficial for them. Hondata is mostly for the bottom end user ,car enthusiast/DIY if you will ,type of customer. Low cost in comparison for the likes of stand...
- Sat Jan 23, 2021 9:31 am
- Forum: Civic Type R 2007-2011 European FN2
- Topic: Tunning help
- Replies: 6
- Views: 3354
Re: Tunning help
If u can find a flat straight road .. virtual dyno can see differences on cam angles and ignition advance
- Fri Dec 04, 2020 4:22 pm
- Forum: FlashPro Manager
- Topic: increese motor power
- Replies: 6
- Views: 2854
Re: increese motor power
<t>You would need to post up a wide open throttle from low rpm all the way to redline datalog and your current calibration.<br/> <br/> Somebody may help you, (I would but I've never messed with k20c)<br/> <br/> <br/> finding the right cam angles, advancing the ignition timing and adding boost would ...
- Fri Dec 04, 2020 10:26 am
- Forum: FlashPro Manager
- Topic: increese motor power
- Replies: 6
- Views: 2854
Re: increese motor power
In any scenario you would need to wait. 1.to get out of the country to find a tuner 2. Find someone who can street tune your motor. 3 teach yourself (although this would better on a naturally aspirated motor as it is more forgiving with mistakes) Please try not to be impatient tuning on a forced ind...
- Fri Jul 24, 2020 6:10 am
- Forum: Civic Type R 2007-2011 European FN2
- Topic: Speed
- Replies: 4
- Views: 6989
Re: Speed
If u have matched it to gps speed be careful of speed camera dash speed is usually a few miles higher than actual for this factor
- Sat Jun 27, 2020 12:52 pm
- Forum: FlashPro Manager
- Topic: Flashpro reset
- Replies: 1
- Views: 4860
Re: Flashpro reset
Just start a new basemap and upload it to ecu
- Sat Feb 29, 2020 8:34 am
- Forum: Civic Type R 2007-2011 European FN2
- Topic: newbie advice please
- Replies: 4
- Views: 6774
Re: newbie advice please
Cold start would be rich anyway, you can set up the flashpro and check air fuel with rev counter.
- Wed Dec 04, 2019 12:07 am
- Forum: Civic Type R 2007-2011 European FN2
- Topic: Help regarding euro fn2 flashpro
- Replies: 2
- Views: 5992
Re: Help regarding euro fn2 flashpro
A couple of knocks is nothing mate could be low quality fuel .. set up your ecu to flash when knock occurs ...low ron fuel or/and lugging the engine (eg 6th low rpm foot flat) can cause knock
- Thu Nov 28, 2019 5:54 am
- Forum: Civic Type R 2007-2011 European FN2
- Topic: Lambda very lean at WOT!
- Replies: 6
- Views: 9229
Re: Lambda very lean at WOT!
No datalog but I was getting 16af on wot changed oring seals and reuploded kal (as ECU was trying to learn with bad seals)
- Wed Nov 20, 2019 3:36 am
- Forum: Civic Type R 2007-2011 European FN2
- Topic: Lambda very lean at WOT!
- Replies: 6
- Views: 9229
Re: Lambda very lean at WOT!
Could be injector oring seals, happened to mine (not supercharged)
- Tue Aug 20, 2019 10:23 am
- Forum: K-Pro / KManager
- Topic: Best wideband for kpro4
- Replies: 16
- Views: 8816
Re: Best wideband for kpro4
Yeah that sounds correct they will both need a signal from the lambda not sure which way round on voltage (not sure why it matters) , there will more than likely be an offset that will need to be calibrated (Just try and calibrate it to same as gauge) and you will need to use the smoothing to slow t...
- Fri Aug 16, 2019 3:29 pm
- Forum: K-Pro / KManager
- Topic: Best wideband for kpro4
- Replies: 16
- Views: 8816
Re: Best wideband for kpro4
Check through this post i made a diy its old so i dont know how relevent it is now
viewtopic.php?f=12&t=18380&start=15
viewtopic.php?f=12&t=18380&start=15
- Wed May 15, 2019 9:44 am
- Forum: FlashPro Manager
- Topic: Cam ignition table help please
- Replies: 7
- Views: 2240
Re: Cam ignition table help please
You can do it that way. You don't exactly need to tune it .. but what if your vtec solenoid stops working and car doesnt go in to high cam. And you lean out bad ? Its just a fail safe to tune as much as you can