4 BAR MAP Sensor

HEATSHIELD | S100 | S300 | REFLASH | K100 | K-PRO | FLASHPRO | TRACTION CONTROL

Information
About Hondata
Applications
Dealers
Prices
News
Cars

Products
Heatshield
OBDI Systems
  s100
  s300
  Accessories
K-Series
  Reflash
  k100
  K-Pro
  FlashPro
Traction Control

Applications
Wizard
By ECU
By Engine
By Vehicle

Support
s300 Help
K-Pro Help
FlashPro Help
Traction Control
CPR Help
Tech
Software
Downloads
Forum

Resources
Media
Dyno Charts
Feedback

  


Hondata, Inc.
2840 Columbia St
Torrance, CA 90503
 

Hondata 4 bar Map sensors

  • B,
  • D,
  • H,
  • F-series,
  • 00-05 S2000
kpro2.jpg (61683 bytes)
  • 02-06 RSX,

  • 06-11 Civic Si,

  • 04-08 TSX,

  • 07-08 Fit,

  • 04-08 TL,

  • 03-07 Accord

kpro2.jpg (61683 bytes)
  • 06-09 S2000,

  • R18,

  • 2012+ SI,

  • 2013+ ILX,

  • 09-10 TSX

  • CRZ

kpro2.jpg (61683 bytes)

 

Overview

The Hondata 4 bar map sensor is a plug compatible replacement for the Honda factory MAP sensor. It is a direct replacement for the B, D, H, F, J and K-series Honda engines. This plug in sensor takes less than 60 seconds to install and eliminates the risk of sensor damage that often occurs when attempting to wire in other types of MAP sensors.

How much do the 4 Bar Map sensors cost?

$99

Important note for automatic transmissions

Automatic transmission computers for the 2009-2010 TSX, 2006-2011 R18 Civic, any CVT CRZ, Asian RRH based Civics share the MAP signal with the fuel injection computer.  If you have an automatic transmission and change the MAP sensor then the AT computer will not work correctly.  You must retain the stock MAP sensor with ATs.

How do I configure my software for the 4 Bar sensor?

SManager & KManager - the settings are found in the 'Parameters' window under 'MAP'.

FlashPro - in the 'Calibration' window under 'Sensors'.

 
 
 

 

Copyright 2014 Hondata, Inc. All rights reserved.
Products are for off road use. Warranty Information